Card sets of gas heater valve installed

(1) according to the requirements of Chapter 9 of the need for pickling pipes should be pickled;
(2) according to the required length by sawing or patio heater gas valve  machines and other equipment off the tube, and definitely not broken with solvent (such as flame cutting) or cutting wheel; remove the tube ends inside and outside round burrs, metal chips and dirt; removing rust-proof pipe fittings agents and dirt; but also to ensure the pipe roundness;
(3) the nut, ferrule has set into the tube, card sets Gas Control Valve the front edge (diameter end) from the mouth of the tube at least 3mm, then taper pipe into the connector body, until the top;
(4) Slowly tighten the nut, turn the gas safety burner valve until it does not move, then tighten the nut 2 / 3-4 / 3 laps;
(5) Remove the check card sets whether to cut the pipe, the location is correct. Card sets are not allowed to move axially to slightly rotate;
(6) Tighten the nuts again after passing inspection.