Gas water heater works

Gas water heater works: when the gas water heaters work, open the gas control valve, gas valve into the pressure difference between A, B two-bedroom; total valve to open water, cold water through the valve all the way into the water total water pressure valve, and the other all the way to the heat exchanger, pressure on both sides of the rubber membrane ranging from pressure to the base film movement, driven by water vapor movement to the left mandrel linkage, toggle lever jack central power switch over to the left so that the power connection jack pass. Electric controller generates high-voltage pulse immediately after power spark, while the miniature solenoid valve 1 is energized, the gas valve into the small fire by the burner, spark ignited a small fire. Water vapor movement to the left ejector linkage in place when the gas burner valves is opening, this time due to valve 2 is already open, the gas did not enter the main burner. Sensor needle was a small fire heat, feel the small fire flame ionic conduction effect, the signal is fed to the electric power supply controller for miniature solenoid valve 2, the valve is closed. From the total gas no longer flows to the valve chamber A gas continuously into the B chamber B when the pressure chamber is greater than the pressure chamber A rubber due to the pressure difference across the membrane is pressed against the A compartment, rubber membrane link A room with the movement of the valve 2 is opened, the gas chamber through C, D room to the main burner, formed by a small fire lit the fire, the flame of high temperature flue gas flowing through the cold water heat exchanger to produce a continuous rapid heating hot water heaters into the normal working condition. A remaining gas chamber so that self-extinguish small fires burn.